Wash&Wear® +PLUS Kitchen&Bathroom Semi Gloss
About Wash&Wear® +PLUS Kitchen&Bathroom Semi Gloss
Dulux Wash&Wear® +PLUS Kitchen & Bathroom Semi Gloss was developed to withstand humid or damp environments. The hard-wearing surface formed by Wash&Wear’s® exclusive 101 Barrier Technology® is fortified with a powerful mould inhibitor and water-repellent properties so you can wipe away most marks with a wet cloth. This gives lasting protection to rooms with damp or humid conditions such as kitchens, bathrooms and laundries, meaning your walls will look freshly painted for years.
Downloads
Application
*Refer to product label for full conditions. This guarantee does not limit and may not necessarily exceed your rights under the Competition and Consumer Act 2010.
At a glance
- Hard-wearing finish that lasts
- Withstands wear and tear
- Withstands frequent cleaning
- Walls look freshly painted for years
- 10-year guarantee against mould growth*
- 101 Barrier Technology®
Areas to use
Performance guide
Dulux Wash&Wear +PLUS Kitchen&Bathroom Low Sheen has been developed to withstand humid or damp environments such as kitchens, bathrooms and laundries.
Surfaces
• Plasterboard
• Brick
• Cement sheet
• Bare timber
• Set plaster
• Fibrous plaster
• Plasterglass
• Masonry
*Refer to product label for full conditions. This guarantee does not limit and may not necessarily exceed your rights under the Competition and Consumer Act 2010.
Previously Painted Surfaces
• Surface must be clean, dry and free from dust, oils and grease.
• Surfaces with cracks or holes with filler: Spot prime repairs with Dulux 1Step® Prep Water Based Primer, Sealer & Undercoat.
Glossy surfaces:
• Lightly sand to a dull finish.
Set plaster, fibrous plaster, plasterglass:
• One coat of Dulux PRECISION® Sealer Binder.
Treating existing mould:
• Remove mould with Selleys® Rapid Mould Killer or by scrubbing with a scouring pad and bleach solution (one part bleach to three parts water).
• Leave solution on the surface for 15 minutes then wash with clean water and wipe dry.
• Several applications may be necessary to remove stubborn mould blooms.
Unpainted Surfaces
Unpainted plasterboard, brick, cement sheet, bare timber:
• One coat of Dulux 1Step® Prep Water Based Primer, Sealer & Undercoat.
Set plaster, fibrous plaster, plasterglass:
• One coat of Dulux PRECISION® Sealer Binder.
Brush, roller
• Stir paint thoroughly with a flat paddle using an up-and-down scooping action.
• Cut-in around the edges with a brush, then roll up to the border whilst it is still wet.
• Apply two coats ensuring that the first coat is completely dry before applying the second.
Unused paint
Do not pour leftover paint down the drain.
Unwanted paint should be brushed out on newspaper and allowed to dry, and then disposed of via domestic waste collections.
For more information on responsible disposal of paint and packaging visit painttakeback.co.nz or paintback.com.au.
Empty paint containers
Leave empty paint containers open in a well-ventilated area to dry out. When dry, recycle the container via steel can recycling programs.
Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your local council first.
Do not reuse container unless thoroughly decontaminated.
For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz
Get in touch with our local Help & Advice team by calling 13 25 25. The Dulux Help & Advice team are experts available to assist with colour, product and service questions.
