PRECISION® Maximum Strength Adhesion Primer
About PRECISION® Maximum Strength Adhesion Primer
The fast-drying Dulux PRECISION® Maximum Strength Adhesion Primer is specifically formulated to bond to a variety of tough-to-paint surfaces that typically resist coatings such as glazed tiles, glass, laminate and glossy enamels.
Downloads
Application
At a glance
- Creates a strong bond for topcoats
- Suitable for use under Dulux topcoats
- Water-based
- Interior and exterior use
- Available in 1L, 4L, 10L
- Superior adhesion to glossy surfaces
Areas to use
Performance guide
For interior & exterior use on a variety of surfaces including:
• Upvc
• Vinyl
• Glass
• glazed tiles
• high gloss enamels
• aged enamels
• Laminex®
• Fibreglass
• galvanized steel
• glazed brick
• chalky paints
• masonry & metals.
Not suitable for Polyethylene, Polypropylene, Teflon or Nylon plastics.
Not recommended for floors or horizontal surfaces subject to prolonged water contact.
Sanding of the primer is recommended prior to topcoating with oil based enamel paints.
Surfaces
• Upvc
• Vinyl
• Glass
• glazed tiles
• high gloss enamels
• aged enamels
• Laminex®
• Fibreglass
• galvanized steel
• glazed brick
• chalky paints
• masonry & metals.
Previously Painted Surfaces
Stained surface:
Remove as much of the stain as possible by cleaning with Selleys® Sugar Soap, sanding, scraping, etc.
Previously painted surfaces:
• Scrape off loose and flaking paint.
• Wash with Selleys® Sugar Soap to remove grease and grime.
• Fill nail holes and cracks with a suitable filler, then sand smooth.
Unpainted Surfaces
Bare timber including weatherboards and hardboards:
Sand bare timber to a clean surface and dust down. Fill nail holes and cracks.
All surfaces must be clean, dry and free of oil, grease, mildew, wax, dust, flaky rust, mill scale, loose paint, chalk and other foreign matter that could interfere with adhesion.
If washing is necessary, use a non-soapy detergent or Selleys® Sugar Soap, rinse well and allow to dry.
While Dulux PRECISION® Maximum Strength Adhesion Primer is formulated to bond without sanding, it is recommended that a small area be tested for adhesion prior to beginning the job.
Brush, roller
1. Eye protection is recommended.
2. Stir well before use with a broad flat paddle using an up and down scooping action.
3. Apply one coat of Dulux PRECISION® Maximum Strength Adhesion Primer.
Do not Tint.
Unused paint
Do not pour leftover paint down the drain.
Unwanted paint should be brushed out on newspaper and allowed to dry, and then disposed of via domestic waste collections.
For more information on responsible disposal of paint and packaging visit painttakeback.co.nz or paintback.com.au.
Empty paint containers
Leave empty paint containers open in a well-ventilated area to dry out. When dry, recycle the container via steel can recycling programs.
Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your local council first.
Do not reuse container unless thoroughly decontaminated.
For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz