Concrete & Paving Crushed Pebble Effect
About Concrete & Paving Crushed Pebble Effect
Dulux Concrete & Paving Crushed Pebble Effect is the final stage in transforming your surface. This finishing coat transforms concrete with a decorative effect that is easy to keep clean and withstands high traffic areas for a durable, lasting finish*.
Downloads
Application
*MUST USE CRUSHED PEBBLE EFFECT ROLLER TO APPLY CRUSHED PEBBLE EFFECT TOPCOAT.
At a glance
- Must be applied with Crushed Pebble Effect Roller
- Available in 10L
- Available in Anchor Bay and Nightfall
- Ideal for paths, patios & steps
Areas to use
Surfaces
Provides a decorative finish ideal for driveways, patios and pathways.
Bare concrete and Sealed surfaces once appropriate preparation has been completed using the Dulux Concrete & Paving Stage 1 and 2 products.
Previously Painted Surfaces
• Use the Preparation table above to determine which cleaner/s and primer/s will be required.
• Stir Dulux Concrete & Paving Crushed Pebble Effect well before and during application with a broad, flat paddle using an up and down scooping action.
• Use a brush to apply to any edges and hard-to-reach places.
• Use the Dulux Concrete & Paving Crushed Pebble Effect roller to apply an even 1st coat of Dulux Concrete & Paving Crushed Pebble Effect.
• Apply from a roller tray or pour directly from the container.
• Work in areas of approximately 1m x 1m. Allow to dry for 4 hours between coats, then repeat steps 2 & 3.
• For optimal results, 2-4 coats may be required to hide previous surface imperfections or cover over contrasting colours.
Brush, roller
Use the Preparation table above to determine which cleaner/s and primer/s will be required. Once surface is properly cleaned and primed, it is mandatory to begin with 1 coat of Dulux Concrete & Paving Coloured Sealer (tinted to colour Dulux Drive Time under Nightfall or tinted to colour Dulux Grey Port under Anchor Bay) before applying Dulux Crushed Pebble Effect finish. Allow to dry for at least 2 hours. Stir Dulux Concrete & Paving Crushed Pebble Effect well before and during application with a broad, flat paddle using an up and down scooping action. Use a brush to apply to any edges and hard-to-reach places. Use the Dulux Concrete & Paving Crushed Pebble Effect roller to apply an even first coat of Dulux Concrete & Paving Crushed Pebble Effect. Apply from a roller tray or pour directly from the container. Work in areas of approximately 1m x 1m. Allow to dry for 4 hours between coats. For optimal results, 2-4 coats may be required to hide previous surface imperfections or cover over contrasting colours.
Unused paint
Do not pour leftover paint down the drain.
Unwanted paint should be brushed out on newspaper and allowed to dry, and then disposed of via domestic waste collections.
For more information on responsible disposal of paint and packaging visit painttakeback.co.nz or paintback.com.au.
Empty paint containers
Leave empty paint containers open in a well-ventilated area to dry out. When dry, recycle the container via steel can recycling programs.
Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your local council first.
Do not reuse container unless thoroughly decontaminated.
For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz
Add a textured decorative look to your patios, steps, and paths without having to replace the surface.
