Stir contents thoroughly before and during use with a broad flat paddle, using an up and down scooping action. Pour the material from the 10L product pail into a 15L application pail – this will act as a roller tray does for normal paint.Application is in two parts: Delivery (via the Dulux Full Cover Roller) and finishing (using a plastic float). Delivery: Generously load the roller directly from the 15L application pail and apply with a smooth, steady action from the ground upwards in vertical strips of half to three-quarter metre lengths. Reload the roller after each strip and repeat until four to five strips are applied. Do not overspread the product. Even out material by rolling diagonally across the surface. It is important to work swiftly to allow time for the finishing process and this can be best acheived by working in a team, with one "delivering" and the other "finishing". Levelling: Holding the plastic float at an angle of about 45 degrees, with the leading edge angled up, and working from the ground up, push the material across the surface to fill joints and low spots. This should level out the texture before it sets. Finishing: After cleaning the plastic float, finish the levelled area in circular strokes to further fill and level out the area. Work in larger, lighter strokes as the material levels out. Lubricate the float intermittently by cleaning with a wet sponge. Repeat the above delivery and finishing procedure, maintaining a working wet edge, until completed. Two coats are recommended but additional coats may be required depending upon the depth of the mortar joints. Remove any masking tape before the coating has dried. See Product Data Sheet for tinting advice.